Sign in

How do I update the Firmware on my Minto?

Last updated
Note! The following instructions applies for version 8.0.6.1 (and above) of the Evoko Control Panel.
  1. Make sure that you have the latest version of the Evoko control panel installed on your PC.
    Otherwise download the latest version from here and install.
  2. Launch the Evoko Control Panel and select the Minto as your product.
    001.png
  3. Make sure that the battery is charged and press "Next".
    002.png
  4. Make sure that the Minto in turned off and disconnected, then press "Next".
    003.png
  5. Connect the Evoko Minto to your computer via the USB cable.
    004.png
  6. Hold down the Vol+ and Vol- buttons and then press the Power button at the same time.
    005.png
    Note! If the Minto doesn't seem to respond/connect then please try pressing the Reset button on the bottom of the Minto and try connecting to the Evoko Control Panel again.
  7. Wait for the Minto to connect.
    006.png
  8. Once the Minto is connected you can now perform the firmware update by pressing "Update firmware".
    007.png
  9. Wait for the firmware update to run.
    008.png
  10. Update successful! Press "Exit" and remove the USB cable.
    009.png
Was this article helpful?
17 out of 39 found this helpful
Have more questions? Submit a request