How do I use the Demo mode on my Minto?

The Minto comes with a Demo mode that can be used to show and test the unit without an active call.

Activate Demo mode

1. Powering up the Minto without connected cables or Bluetooth connection.
2. Press the Vol- and Power buttons simultaneously for 3 sec.
3. A positive beep is heard when Demo mode is activated. The Minto will automatically start to clear the memory and the Halo light is breathing red until the memory is cleared.
4. Once the unit beeps and the Halo light turns steady blue it is ready to be used.

Use Demo mode

1. While the Halo light is steady blue press the Bluetooth button to start recording.
   The Halo light will become steady green and will be recording for 12 sec.
2. When 4 sec. is left of the recording Minto starts flashing green.
3. After 12 sec. the Minto beeps and automatically plays back the recording while breathing blue.
4. After playback, the memory is cleared again and when the Halo light turns steady blue it is ready to start a new recording (see step 1).

De-activate Demo mode

• Pressing Vol- and Power key simultaneously for 3 sec. or
• Turning off the device